Understanding your FESCO bill and the estimate above
Households in Sargodha often find that the amount on the bill is higher than what they expected from the units they used. This page explains where the money goes so you can check a bill line by line and see whether the estimate from the calculator is reasonable.
Step one: work out your units
One unit is one kilowatt-hour. The units billed are the current meter reading minus the previous reading. Look at the two readings printed on your bill and subtract them yourself. If the figure does not match, or the previous reading is wrong, the error will flow into every other charge.
What is added to the unit price
- Energy charges. Units multiplied by the rate for your slab. Higher slabs cost more per unit, so staying under a slab limit matters more than a few units suggest.
- Fixed charges. A monthly amount that depends on your connection type and sanctioned load, charged even if you use little.
- FPA (fuel price adjustment). A per-unit adjustment for the difference between the fuel cost assumed in the tariff and the actual cost. It can be positive or negative and changes from month to month.
- QTA (quarterly tariff adjustment). A per-unit adjustment applied after the regulator reviews a quarter.
- Taxes and duties. General sales tax and electricity duty, calculated on the earlier amounts. Commercial connections may also have income tax withheld.
The calculator applies the slab rates and these adjustments to the units you enter. Use it to compare two months, or to see what a drop of 50 units would save.
Why your real bill may still be different
- Arrears or a late-payment surcharge from an earlier month are added to the total.
- Rates and adjustments are revised by the regulator, NEPRA, and the notified figure for your billing month may differ from the one used here.
- Whether you fall in a protected or unprotected category depends on your recent usage and on rules that have been changed several times.
- Estimated or average billing is used when the meter reader cannot take a reading.
If you think the bill is wrong
First compare the bill with the photo or reading of your meter. If the readings are wrong or the units look too high, complain before the due date: call the FESCO helpline on 118 or visit your sub-division office. Our utilities page lists offices, and each sub-division guide explains the complaint steps. Keep the complaint number, and ask for a corrected bill so you are not charged a surcharge while the matter is being checked.
Practical ways to use fewer units
- In summer, set the air conditioner to around 26 degrees and use a fan alongside it. Each degree lower raises consumption noticeably.
- Switch remaining bulbs to LED and put water pumps and irons on a routine instead of leaving them on.
- Clean air-conditioner and refrigerator filters and door seals; dirty ones make the compressor run longer.
- Read your own meter on the same day each week. A sudden jump with no change in habits can point to a fault or a leakage somewhere in the wiring.